Quick Fit Solderless 2 End Wire Cable For DC LED Strip Lights

A pre-wired, solderless connector cable for DC low voltage LED strips. It allows you to join two LED strips or extend a strip without soldering, making installations cleaner and faster.

How to Use:

1. Turn off the power – Always disconnect the power supply first.
2. Cut the LED strips – Cut only on the marked cut line.
3. Open the connectors – Lift the small plastic clips on each end.
4. Insert the LED strips – Slide each strip into one end of the connector. Ensure the copper pads sit under the metal pins.
5. Align all pins – For multi-channel strips (RGB, RGBW, etc.), make sure each channel matches correctly.
6. Close the clips firmly – Press down until they click shut.
7. Test the connection – Turn the power back on and check the strips light up correctly.

Notes:

1. Supplied as a pack of 5 connectors.
2. Double-check polarity (+ / –) before closing the connector to ensure correct operation.
3. For DC low voltage LED strips only. Not suitable for mains or high voltage strip lights.